05/08/2026

Pressure regulating valves (also known as pressure reducing valves) are crucial devices in industrial and commercial piping systems. Their primary function is to maintain a stable downstream pressure, regardless of upstream pressure fluctuations or changes in flow rate. Depending on the application, selecting the appropriate valve is essential to ensure efficient and safe operation of the valve and the entire system.

30/07/2026

At startup, the pressure regulating bolt is in the loosen state, the inlet steam pressure and the valve seat spring are in the closed state. We begin by turning the pressure regulating bolt on top of the valve clockwise. The bolt moves linearly, pushing the spring downwards, simultaneously lowering the valve diaphragm, controlling the valve to open, and the fluid and outlet pressure begin to increase. The pressure inside the valve body pushes the diaphragm upwards, balancing the spring force. The pressure after the valve increases simultaneously until it reaches the set pressure value, at which point the valve begins to close gradually, preventing the pressure after the valve from exceeding the set threshold.

12/02/2026

When the pressure of saturated condensate is reduced, a portion of the liquid “flashes” to low-pressure steam. Depending on the pressures up stream, the flash steam contains normally 3% to 50% of the energy content of the original condensate. Almost cases, condensate receivers the flashing steam is vented to atmosphere and its energy content lost. 

11/02/2024

22/08/2023

There are three main forms of energy used in industrial processes: electricity, direct heat, and steam.

02/09/2020

28/04/2021

07/04/2022

16/02/2024

CEFI STEAM TRAP CEFI steam trap one piece design with custom orifice made from special stainless and the most advanced steam traps on the market, reduces energy loss, has the ability to automatically regulate discharge flow through the condensate water system. There are no moving parts inside so the possibility of damage and need for maintenance during operation is low. Connect the steam trap to the pipeline system with flanged. Steam traps are designed up to size DN50 with variety flows rate. It is depending on each the technological system. Install horizontally or vertically. The direction is marked on the steam trap body. Guaranteed successful operation with each application. Steam trap application for heating systems, moisture separation, water discharge on main pipeline.  

14/10/2024

Why do we need to use saturated steam pressure reducing valves? All equipment and piping systems have design pressure and maximum working pressure values. During equipment operation, the fluid pressure needs to be lower than the equipment's working pressure within a certain temperature range. If the fluid pressure exceeds the equipment's working pressure, it needs to be reduced to below the equipment's maximum working pressure. This ensures the system and equipment operate properly, reducing the risk of equipment damage and malfunctions due to overpressure.

17/07/2024

22/10/2020